AD00018RE Transparent seal type single touch switch

This is a module set that enables capacitive touch at low cost.

This is a capacitive touch switch that uses a transparent electrode film as a sensor.
Compared to sensors that use ITO, capacitive touch sensors can be constructed at a lower cost.
Simply connect the power supply and signal lines and it can be used immediately as a touch sensor (switch).

Free design is possible

Double-sided tape is attached to both sides of the film, making it easy to apply.
You can use it by sticking it to the back of a plastic case or acrylic plate that is about 2mm thick.

Relay contact specification that can be used immediately as a touch sensor!

The relay contact output with terminal block can be easily installed with a flat-head screwdriver.
Simply connect the power supply and signal lines and it can be used immediately as a touch sensor (switch).
The switch operation can be switched between "momentary" and "alternate."